August 24, 2000
“I wanted to share the new HeatMAX test result with you! I started the test
at 5:pm. At 7:pm, I recorded the temperature of the test flame in its
enclosure. Over 5 minutes the highest reading was 161.4 F. Then, with the
same flame burning, I installed the new HeatMAX and walked away for another
2 hours. At 9:pm I recorded the temperature over the next 5 minutes. The
highest reading was 225.8 F. An increase of 64.4 degrees F ! That converts
to an increase in HEAT per unit to 39.9% !”
- A Message from Dr. Robert
Kane
"We
have tried said system on our steam boilers, which are operating with fuel
oil, under the supervision of our factory Engineering Department." "Saving
percentage is 19%."
- Director General, Engineering Shamsi Textile
Industrie
"In
addition to above; utilization of HeatMAX (FuelMAX) extends life of boilers
by means of removing carbon residues inside boiler incinerator and flame
pipes thus reducing the need for periodic maintenance. " The factory
Engineering Department recommends utilization of this system with all
factory boilers, vehicles, and engines."
- Director General, Engineering Shamsi Textile
Industrie
|